INDUcoder Messtechnik GmbH - Inquiry

We measure angles and distances.
Digitally.
Absolutely and Incrementally.

Digital Encoders for position and angle sensing.

I.	ABSOLUT ENCODER read-out an absolute coded data information on the actual position within their full range with resolution and parameters to order, which is also able to be read-out after supply voltage was cut off.
II.	INCREMENTAL ENCODER generate pulses with resolution and parameters to order to be counted up and down by external electronic device for relative position measurement from a defined set-point.

Encoders' definition is ruled by the application and ambiance to operate in:

1.	Linear Displacement Transducer with shaft encoder or potentiometer: simple to handle, no extra space required
2.	Shaft Encoders for position sensing via spindle drive or geared motor or by measuring wheel or belt transmission or similar
3.	Encoders for angle sensing Shaft encoders need coupling and centered mounting face Hollow shaft encoders are set direct onto the drive shaft
4.	Manual Pulse Generators and Hand-Held Terminals - incremental encoders

INDUcoder PRODUCTGUIDE:

	MICRO- / MINI-ENCODER	Incremental Shaft Encoder	Diameter 12 - 28 mm
	EURO ENCODER	Incremental and absolute Shaft- and Hollow Shaft Encoder	Diameter 30 - 50 mm
	STANDARD ENCODER	Incremental and absolute Shaft- and Hollow Shaft Encoder, fieldbus interfaces	Diameter 58 - 120 mm
	MOTOR-FEEDBACK SYSTEMS	built-in Hollow Shaft Encoder with / without commutation tracks	Diameter 26 - 46 mm
	LINEAR DISPLACEMENT TRANSDUCER	range up to 50 m, resolution from 10 µm	Diameter 42 - 200 mm
	MANUAL PULSE GENERATORS	Absolute and incremental encoders, all fieldbus interfaces, programmable, up to 30 bit or up to 10.000 pulses per revolution	very flat design
	ROBUSTE ENCODER SYSTEMS For crude ambiance	Incremental / absolute Shaft- and Hollow Shaft Encoder built-in stainless steel housing IP 67, -40 ... +200°C, redundancy, fieldbus interfaces

Information request

	Please send technical data on products ticked
	Offer required
	Please phone to discuss a new design/project with encoder(s), according to the following short description:

Ms. / Mrs.

Mr.

Name

Title

Company Name

Department

Address

City, State, Zip

Country

Phone

Fax Number

Email

Internet

INDUcoder Messtechnik GmbH, P.O. Box 18 03 49 47173 Duisburg, Germany	Phone:+49 203 57047-0, Fax:+49 203 57047-20 Email: aibncfdoe@fignhdiujckoldmenropdres
Technical changes to alteration. Publication of the shown data only with written authorization of INDUcoder Messtechnik GmbH.